Rock crusher conveyor and fabrication

We designed and built a primary conveyor for a rock crusher from scratch, and fabricated much of the steelwork around it.

Rock crusher primary conveyor built from scratch

Primary conveyor

The conveyor is built in three sections. The tail pulley section is hinged so it can be lifted for more ground clearance in transport.

The tail pulley tension adjusters have 12 inches of travel on 1-inch stainless threaded rod, and they’re fully greasable.

Catwalk, decks and ladders

An upper deck for viewing the jaw and a lower deck for motor access. The upper railing slips into receivers and has a built-in ladder for looking down into the jaw.

Catwalk, railings and ladder fabricated for a rock crusher
Catwalk, decks and ladders.

Guarding and side panels

The jaw guarding is 3/4-inch plate on the sides and 1/2-inch at the rear. The side panels were flame cut from a single 4x8 sheet of 3/4-inch plate.

Side panels fabricated from 3/4 inch plate for a crusher jaw
Side panels for the crusher jaw.

Wear plate and supports

We installed T100 wear plate in the grizzly feeder in 18-foot strips, mitred, fitted and welded in the shop.

The jaw box weighs 49,900 lb. It sits on a support beam system with 1-inch adapter plates and extra beam stiffeners.

Rock crusher jaw box on its support beams
The jaw box on its support beams.

Call or email about your job

Phone is the fastest way to reach us. For email, send photos and the details below.

What to send

  • Where the job is
  • The equipment or item, with make and model if it has one
  • The material, if you know it
  • What’s broken, or what you want built
  • A few photos, including one of the whole item